CV joint adaptor kit for Piranha

Adaptor kit to fit Porsche 924 axles & CV joints to the Piranha. Includes the following parts: 1x Splined Centre shaft, 2 x Splined axles with billet wheel hubs, (4 stud 115mm PCD) 4 x CV splined adaptor hubs, 4 x retaining bolts & washers. To suit type 2 CV joints of 6 x M8 bolts on 86mm PCD. This kit suits Single or Double A arm rear suspensions & replaces parts PIR06 & IND-08. Part PIR12, (driveshafts) are replaced by purchasing original Porsche 924 CV joint/axle assemblies. Instead of

---

Piranha Chassis (Fully Welded)

Chassis fully welded & drilled with rollbars & all

---

Rear Axle

AXL-02, Rear Axle, 1120mm long, 4140 steel with keyways & wheel hubs fitted. comes with Mini, (101.6mm) four stud pattern. Please advise if you require a different stud pattern

---

Front brake upgrade

Front Brake upgrade for Barracuda when fitting 15” wheels. Right & left sides. Uprights are of a new design that has increased kingpin inclination to compensate for the heavier steering induced by 15” wheels. Bigger floating rotors & Wilwood calipers. Awesome braking power. NOTE: ¾” master cylinder is required. Kit Includes: 2 x FWH-04 alloy hubs, 2 x Stub axles, 2 x Wilwood calipers, 2 x 312mm diameter 6mm thick floating rotors, Bearings & seals, studs & nuts.

---

Fuel Tank Aluminium

Barracuda 20 litre Aluminium fuel tank, high capacity, racing filler cap. Includes welded on mounts to tank & mount tags ready to weld to chassis. Comes with a welded in flange that fits the in-tank Hayabusa fuel pump.